If you have a big lawn or a garden, then a lawn mower is a must to have. Scott lawn mowers are among the most popular choices among lawn owners in the USA. But these mowers also frequently experience a problem with not turning over, much as other mowers.
Your Scott lawn mower not starting might be caused by a variety of reasons. Common reasons are a dead battery, a dirty air filter, damaged spark plugs, and more. All these problems are, however, solvable by following a few steps.
So. If your Scott lawn mower is having problems and you are looking for how to fix them, our guide today will help you with that.
Why Won’t Your Scott Lawn Mower Turn Over?
There could be a number of causes for your Scott lawn mower to not turn over. As your lawn mower gets old, problems like a dead battery, bad spark plugs, and damaged air filters start to happen, resulting in your mower not starting. Down below, we will look at all the reasons for these issues.
- Dead Battery
- Dirty Air filter
- Problematic solenoid
- Damaged Spark Plug
- Problem with the fuel pump
- Faulty Charging Circuit
6 Solutions For Scott Lawn Mower Will Not Turn Over
So far, we have seen all the probable reasons for your Scott lawn mower not reversing. To your luck, down below, we will discuss how you can solve all these issues quickly without much trouble.
1. Dead Battery: Clean or Replace
The battery is one of the key components for any lawn mower; it is impossible for a mower to function without a fully working battery. Sometimes if you leave your mower without running for too long, the battery can become dead.
First, check the battery terminals for corrosion; properly clean using baking soda and water. Now take a multimeter and place it on the terminals, and if your battery is 12 V, you should have a 12.7v reading. If it has a lower reading, try recharging the battery. If it still doesn’t work, then you will need to replace the battery.
Battery replacement can cost anywhere from $60-$100, depending on your lawn mower model.
2. Dirty Air Filter: Clean the Filter
Another common reason for mowers not switching back is dirty air filters. Combustion might be hampered by an air filter that isn’t allowing sufficient air into the engine.
The mower will be covered in a thick layer of dust because you’ll be cutting grass with it. As a result, grass clippings might block the air filter, especially while mowing a damp lawn.
To clean the air filter, start by locating the filter and giving it a thorough cleaning with an air blower. In most circumstances, this ought to be sufficient, but if it isn’t, you’ll need to replace it. Replacement air filters can cost between $7-$10.
3. Problematic Solenoid: Replace it
A lawn mower solenoid functions as a kind of on/off switch. An electromagnet switch is activated to activate the starting motor and ignite your engine. There is no specific reason for it to get damaged; it can wear down over time.
If you see that the ignition key is making a sound or when starting the mower, smoke is coming out; the solenoid has gone bad. You will need to replace it if it has gone bad. Unfortunately, replacing solenoids isn’t easy, and you will need to visit a professional service station.
Depending on where you are, a solenoid replacement costs between $112 and $123. Additionally, labor expenses between $30 and $50 will be incurred.
4. Damaged Spark Plug: Clean, Tighten or Replace
Spark plugs are a crucial part of lawn mowers because they spark the fuel-and-air combination within the engine’s chamber. If the spark plug is broken, disconnected, or covered in carbon or water residue, it can be the cause of your machine’s malfunction.
You must thoroughly examine the spark plug. If the connections are loose, simply tighten them using a screwdriver and a wrench. However, for dirty spark plugs, try to clean them. If it is impossible to clean them, replace them with new ones.
Replacement spark plugs cost very little; you will find them available for around $5, and you can replace them yourself.
5. Problem with the fuel pump: Clean or replace the fuel pump
This is one of the rarest reasons for the lawn mower engine not turning over. Your engine receives oil and gasoline through the fuel pump. However, the components of the pump might deteriorate over time as a result of the old gasoline remaining in the pump.
Check your fuel pump if there’s any fuel on top of it. If yes, then pump all the old fuel out of the pump and clean the pump correctly and remove all dust and debris. If the pump still doesn’t work properly, you will need to replace it.
Replacing fuel pumps typically costs from $880 and $1000. While parts are priced from $600 and $780, workers’ wages are predicted to be between $150 and $200.
6. Faulty Charging Circuit: Check and Replace the Components
Your Scott lawn mower may occasionally not turn over even though the battery is in good condition. The source of this problem is a faulty charging circuit, and as a result, the battery will be discharged faster.
Circuit components are quite critical, and it is very common for some components to get damaged or some wires to come off. This is a critical problem to detect by yourself, so you should visit a lawn mower dealership.
Fixing the charging system can cost anywhere between $40-$100 depending on the degree of damage and
FAQs About Scott Lawn Mower Not Turn Over Issue
This section is all about FAQs, and below, we will answer a few of these questions, which will further clear all your doubts about today’s discussion.
What would cause a Scott Lawn Mower not to turn over?
There are various reasons for which Scott Lawn mower would not turn over. The most common reasons are a dead battery, faulty or damaged spark plugs, and a dirty air filter. It is important to properly detect the exact issue before finding the fixes for them.
When I turn the key on my Scott lawn mower and nothing happens?
The solenoid should connect with a single click sound as soon as you turn the key. However, if it makes a humming noise and nothing happens, that means you have a defective starting solenoid that needs to be repaired or replaced.
Why does my Scott Mower’s motor spin but doesn’t crank the engine?
If the starting motor turns, but the engine won’t start, your battery is either faulty or damaged. Examine the batteries and charging circuit for flaws to solve this issue.
How do I know if the starter is faulty in my lawn mower?
When a mower is having trouble starting, it may make a screaming sound without the engine turning over and make a beeping sound when the ignition is turned on, or just not respond at all.
Scott Lawn mowers are one of the most popular lawn mowers out there due to their efficiency and performance. But, as they age, they start showing problems, and you will often find them not turning over.
Well, the reason for your mower not turning over is not that complicated and can be fixed quickly. Thus, today in this guide, we discussed all the probable reasons for your mower not turning over, along with quick fixes for them that you can try,
Make sure to read this guide properly before troubleshooting the problems. If you are still unable to detect the issues, it is best to take your Scott lawn mower to a dealership and have it checked thoroughly.
- Troubleshooting tips for a Husqvarna riding mower that is not moving forward or reverse
- issues with one side of a Husqvarna zero-turn mower not functioning properly
- Common issues and troubleshooting advice for Yamaha lawn mower engines.
- Recognizing the signs and symptoms of a faulty solenoid in a riding lawn mower
- Reasons Why Your Lawn Mower Starts Then Dies Right Away